Use And Care Manual

10
OPERATING PROCEDURES
LOADING THE FASTENERS
1.
Disconnect the tool to the air supply before
loading fasteners to prevent fasteners from
firing during connection. The fastener driving
mechanism may cycle when the tool is
connected to the air supply.
2.
Depress the safe cover to release the movable
magazine unit and pull the magazine out fully
as shown in Fig.4.
4.
Push the movable magazine unit forward until
the magazine latch clicks and locks it.
5.
The tool is ready to operate.
3.
Place a full stick of the desired type and size
of fasteners on the fixed magazine unit. Up to
100 fasteners can be loaded in the magazine.
Fig.4
CAUTION: Do not load with contact safety mechanism or trigger
depressed.
Fig.5
Fig.6
NOTE:This 2 in 1 nailer/stapler
accepts nails and staples show
in (Fig.7).
Fig.7
13mm (1/2")
16mm (5/8")
19mm (3/4")
25mm (1")
32mm (1-1/4")
38mm (1-1/2")
40mm (1-5/8")
5.7mm (1/4")
1.26mm x 1.05mm
(0.050" X 0.041")
1.26mm x 1.05mm
(0.050" X 0.041")
10mm (3/8")
15mm (5/8")
20mm (3/4")
25mm (1")
32mm (1-1/4")
38mm (1-1/2")
40mm (1-5/8")
30mm (1-3/16")
35mm (1-3/8")
45mm (1-3/4")
50mm (2")
2mm (0.079")
18GA Brad Nail
18GA Staple