Installation Instructions

ManualsBrandsPerformax ManualsAutomotiveAluminum Cargo Carrier 40" Ramp

with 41” Long Ramp

Read and understand this entire manual before assembling,

installing, operating, or servicing this product.

SAVE THIS MANUAL

Aluminum Cargo Carrier

Model 261-3329

Instruction Manual and Parts Catalog

herein may be reproduced in any shape or form without the express written consent of Menard, Inc. Due

to continuing improvements, actual product may differ slightly from the product described herein. Tools

required for assembly and maintenance may not be included.

Summary of content (6 pages)

PAGE 1
Aluminum Cargo Carrier with 41” Long Ramp Model 261-3329 Instruction Manual and Parts Catalog Read and understand this entire manual before assembling, installing, operating, or servicing this product. SAVE THIS MANUAL Copyright 2015 Menard, Inc. All rights reserved. No portion of this manual or any artwork contained herein may be reproduced in any shape or form without the express written consent of Menard, Inc.
PAGE 2
IMPORTANT SAFETY INFORMATION This is a SAFETY ALERT symbol. It is used to alert you to potential personal injury hazards. Obey all safety messages that follow this symbol to avoid possible injury or death. WARNING concerning Risk of Eye Injury. Wear ANSI approved eye protection. WARNING concerning Risk of Hearing Loss. Wear hearing protection. DANGER DANGER indicates a hazardous situation which, if not avoided, will result in death or injury.
PAGE 3
Personal and Work Area Safety (continued) unloading the Carrier. F. While assembling and using the Carrier keep work area clean and well lighted. Keep spectators and children out of the work area. H. Note the position of the vehicle’s exhaust pipes before setting up the Carrier. Make sure exhaust pipes are not in close proximity of the Carrier; ﬂammable goods in the Carrier could catch on ﬁre due to heat from exhaust. If this risk exists on your vehicle, do not use the Carrier. 3. Use of the Carrier A.
PAGE 4
Assembling and Setting Up the Aluminum Cargo Carrier with 41” Long Ramp End Supports (10) Middle Supports (7) Upper Brace (4) Carrier Base (2) Vertical Supports (8) 5. Next, attach the two End Supports With Reﬂectors (9) to further support the Upper Brace/Carrier Base. These End Supports With Reﬂectors go on back of Carrier. Use same hardware: (16) and (17). End Supports/ Reﬂector (9) 1.
PAGE 5
position, and is held in place using two Pins (11) and two Lock Pins (12) (see photo to right). 12. The Carrier is now Pin Lock Pin (12) (11) ready to be attached to the vehicle’s receiver hitch. With assistance, lift the Carrier and insert the Carrier’s Hitch Bar Assembly (3) into the vehicle’s receiver hitch. Insert the Hitch Pin (5) through the hole openings in Hitch Bar and receiver hitch. Secure the Hitch Pin with the Hitch Lock Pin (6). Loading and Unloading the Aluminum Cargo Carrier 1.
PAGE 6
Parts List Part # Description 1 2 3 4 5 6 7 8 9 10 11 12 Ramp Carrier Base Hitch Bar Assembly Upper Brace Hitch Pin Hitch Pin Lock Middle Support Vertical Support End Support/Reﬂector End Support Pin Lock Pin Qty 1 1 1 1 1 1 2 5 2 4 2 2 Part # 13 14 15 16 17 18 19 20 21 22 23 Description Qty Hook for Tie Down Washer (M6) Nut (M6) Bolt, Small Head (M5x12) Lock Nut (M5) Bolt, Large Head (M8x30) Lock Nut (M8) Bolt, Med.