Use And Care Manual

GENERAL MAINTENANCE
Page 18
MAINTENANCE
WARNING: For your safety, turn the switch off and remove the plug from the power source before performing
maintenance or lubrication work on the lathe.
• Blow out dust accumulation inside the motor, housing, and bed assembly frequently. If the tailstock has been used as
a guide for drilling through the centre of a workpiece, also blow sawdust or shavings out of the centre of both spindles.
• A coat of automotive wax applied to the bed will help keep the surface clean and the movement of the tool rest and
tailstock smooth.
• Periodic lubrication of the spring levers and other threaded parts will make these parts easier to operate.