Use And Care Manual

Page 14

ASSEMBLY

INSTALLING HEADSTOCK SPUR

CENTER AND TAILSTOCK CUP CENTRE

(Fig. 5a-5b)

• Insert the shaft of the headstock spur centre (A) into the

hollow centre of the headstock spindle (Fig. 5a).

• Insert the shaft of the tailstock cup centre (B) into

the hollow centre of the tailstock spindle (Fig. 5b).

FIG. 4b

FIG. 5a

FIG. 5b

CAUTION: The faceplate has an open centre, so

that when drilling through a workpiece from the tailstock

the drill bit can go completely through the workpiece.

CAUTION: Since the headstock spindle is belt

driven, it will turn freely if not held stationary while the

faceplate is tightened or loosened.