Use And Care Manual
WARNING: To avoid injury, do not connect this mini wood lathe to a power source until it is completely assembled
and adjusted and you have read and understood the operator’s manual.
CAUTION: This tool is heavy. To avoid back injury, must lift with the help of another person.
CAUTION: To hold the lathe securely, the bolts must engage a minimum of 1" (2.5 cm) into the frame.
(ITEMS NOT SUPPLIED)
Screwdriver
(ITEMS SUPPLIED)
Flat wrench (1 pc)
Push-out rod (1 pc)
3mm Hex key (1 pc)
4mm Hex key (1 pc)
8mm Hex key (1 pc)
UNPACKING YOUR MINI WOOD LATHE
YOU WILL NEED
This product requires assembly.
• Carefully lift mini wood lathe from the carton and place it on a level work surface.
• Inspect the tool carefully to make sure that no breakage or damage occurred during shipping.
• Do not discard the packing material until you have carefully inspected and satisfactorily operated the tool.
• Do not clean the lathe with anything other than a damp cloth or a mild solvent. Use of heavy solvents, paint thinner,
gasoline, etc. will damage painted surfaces.
• If any parts are damaged or missing, please call 1-877-684-8912 for assistance.
WARNING: The use of attachments or accessories not listed in this manual might be hazardous and could cause
serious personal injury.
WARNING: Do not attempt to modify this tool or create accessories not recommended for use with this tool. Any
such alteration or modication is misuse, and could result in a hazardous condition leading to possible serious personal
injury.
WARNING: Do not connect to the power supply until assembly is complete. Failure to comply could result in
accidental starting and possible serious personal injury.
WARNING: The lathe must be bolted to a bench top. Operating a lathe that is not bolted down may
result in serious injury.
Page 11
ASSEMBLY
MOUNTING THE LATHE ON A BENCH TOP (Fig. 2a-2b)
• In a clear space on the bench top, measure and mark three hole centres as shown in Fig. 2.
• Drill clearance holes through the bench top. Position the mini wood lathe assembly (A) on the bench top (B).
• Install the hexagon socket bolts M10 x 40 (C) and at washers 10 (D) included from underneath the bench top into the
tapped holes in the bottom of the lathe frame.