Assembly Instructions Item # 245-1883 Model # M52MWC9-TL USE AND CARE GUIDE 52‘’ 9 DRAWER MOBILE WORK BENCH Questions, problems, missing parts? Before returning to the store, call 1-866-441-5080 9 a.m – 6 p.m.
Table of Contents Table of Contents .................................................. 2 Assembly ............................................................... 6 Safety Information ............................................... 2 Operation .................................... .......................... 7 Warranty ................................................................ 4 Cordless Power Tool Battery Chargers ............... 7 Specifications ...................................................
7. Extension cord □ Follow all manufacturers' Warnings and Operating Instructions for your extension cord. □ Do not insert extension cord through hole without grommet in place. □ Only use a three-wire extension cord with all three prongs intact. Never remove the round grounding prong. □ Extension cord must be connected to a 125 Volt GFCI protected outlet with proper ground. If GFCI outlet is not available, use an extension cord with GFCI protection built in.
Limited Lifetime Warranty PERFORMAX® Tool Cabinets and Chests are warranted to be free from defects in materials and workmanship under normal use for the lifetime that you own the product. If any part of the product is found to be defective during normal use, the defective product or part will be replaced at our discretion. This warranty does not cover products that are damaged through accident, abuse, misuse, commercial/industrial applications or neglect.
Package Contents (continued) NOTE: Cabinet Keys are inside top drawer.
Assembly 2 Attaching the casters CAUTION: Two people are recommended for assembly. 1 □ Be sure the drawers are locked and lay the cabinet (A) □ □ Position the cabinet handle (B) over the holes on the cabinet (A). □ Attach with the bolts (BB) and tighten with supplied hex key (CC). Attach the swivel casters (D) to the unit, on the same side as the handle, inserting bolts (AA) through the swivel casters(D) and into the cabinet (A).
Operation 1 Removing the drawers □ □ □ 2 Re-inserting the drawers □ □ Fully extend the empty drawer. Push up the one release lever while pulling down on the other release lever. Pull the drawer outward until it is released from the drawer slide. □ Extend the drawer slides. Insert the brackets on each side of the drawer into the slots in the slides, being careful that they are properly positioned. Once properly inserted, completely close the drawer to set the slides in their proper positions.
Maintenance 1 2 Caster maintenance Drawer maintenance □ Grease the casters annually using high-quality bearing grease. □ □ □ Periodically clean the drawer fronts, drawer trim, and other surfaces with a mild detergent and water. Lubricate the slides semi-annually with high-quality bearing grease. you would on a car. □ Replacement Parts For assistance with replacement parts please call 1-866-441-5080.
