Use And Care Manual

11
INSTALLING THE DUST BOX ASSEMBLY
1. Insert the dust duct box assembly (1) onto
the dust chute (2) (Fig. 1).
2. Push the dust box assembly fully onto the
dust chute.
NOTE: Remove and clean the dust box
assembly periodically to remove
accumulated dust from the dust box.
CLEANING THE DUST BOX
The dust box will collect much of the sanding
dust that is generated during sanding operations.
As a result, it must be cleaned out periodically
so the dust collection will be efficient.
1. Grasp the sides of the dust box (1) and pull
it away from the rear of the dust chute (2)
(Fig. 2).
2. Insert a small flat blade screwdriver at the
front of the dust box assembly (3) and
carefully pry the top of the dust box (4)
away from the bottom of the dust box (5)
(Fig. 3).
NOTE: It is best to perform this function
either outside or over a trash can, as loose
dust will come out of the dust box very
easily.
3. Shake all the dust out of the dust box.
4. Use a soft DRY brush to remove the dust
from the filter located inside the top of the
dust box.
5. Once all the sanding dust is removed from
the dust box, press the upper and lower
sections together. They will “snap” into
place when properly assembled.
6. Reinstall the dust box onto the rear of the
sander.
NOTE: Make sure the dust box assembly
is fully pushed onto the rear of the sander.
INSTALLING SANDPAPER
WARNING:
Unplug the sander from the
power source before installing or changing
the sandpaper.
1. Firmly press the sandpaper (1) onto the
hook & loop pad (2) (Fig. 4).
NOTES:
a) Place the sandpaper so the holes line up with
the matching holes in the hook & loop pad.
b) Press the sandpaper firmly onto the hook &
loop pad.
ASSEMBLY AND OPERATING
!
Fig. 1
1
2
Fig. 2
1
2
Fig. 3
3
4
5