Installation Instructions

Page 34
TROUBLESHOOTING
PROBLEM
CAUSE
SUGGESTED CORRECTIVE ACTION
Brake does not
stop blade within 10
seconds.
1. Motor brushes not
sealed or lightly sticking.
2. Motor brake overheated
from use of defective or
wrong size blade or rapid
ON/OFF cycling.
3. Arbor bolt is loose.
1. Inspect/clean/replace brushes.
See MAINTENANCE section.
2. Use a recommended blade.
3. Retighten.
Motor does not start. 1. Brush is worn. 1. Replace brushes.
2. See MAINTENANCE section.
Brush sparks
excessively when
switch is released.
1. Brush worn / damaged. 1. Replace brushes.
See MAINTENANCE section.
Angle of cut is
inaccurate.
1. Miter table unlocked.
2. Too much sawdust
under table.
1. Use miter locking knob to tighten
the miter table.
2. Vacuum or blow out dust.
WEAR EYE PROTECTION!
Cutting arm cannot
fully raise or blade
guard cannot fully
close.
1. Sawdust buildup. 1. Clean and lubricate moving parts.
Blade binds, jams,
burns wood.
1. Improper operation.
2. Dull blade.
3. Improper blade.
4. Warped blade.
1. See OPERATION section.
2. Replace blade.
3. Replace blade.
4. Replace blade.
Saw vibrates or
shakes.
1. Saw blade damaged.
2. Saw blade loosened.
1. Replace blade.
2. Tighten arbor bolt.
Laser line projection
is hard to see.
1. Light in work area is too
bright.
2. Sawdust on the laser
lens.
1. Move the Miter Saw to the work
area with proper light.
2. Clean laser lens with a soft,
dry brush.