Installation Instructions
Page 30
MAINTENANCE
WARNING:
OPERATION
Key Miter Setting Bevel Setting Type of cut
IL 31.6° Right 33.9°
Inside corner - Left side
1. Position top of the molding against the fence.
2. LEFT side is nished piece.
IL 31.6° Left 33.9°
Inside corner - Left side
1. Position bottom of the molding against the fence.
2. LEFT side is nished piece.
IL 31.6° Right 33.9°
Outside corner - Left side
1. Position bottom of the molding against the fence.
2. RIGHT side is nished piece.
OR 31.6° Right 33.9°
Outside corner - Right side
1. Position top of the molding against the fence.
2. RIGHT side is nished piece.
Crown molding has a high top rear spring
angle (the section that ts at against the
ceiling) of 52° and a bottom rear spring angle
(the section that ts at against the wall) of
38°.
To ensure safety and
reliability, all repairs should be performed
by a qualied service technician.
When servicing, use
only identical replacement parts. The use
of any other parts may create a hazard or
cause damage to the product.
Unplug the Miter saw
from the power source before cleaning or
performing any maintenance.
Always wear safety
goggles or safety glasses with side
shields during power tool operations, or
when blowing dust. If operation is dusty,
also wear a dust mask.
Periodic maintenance allows for long life
and trouble-free operation. A cleaning,
lubrication and maintenance schedule
should be maintained. As a common
preventive maintenance practice, follow
these recommended steps:
1. When work has been completed, clean
the tool to allow smooth functioning
of the tool over time.
2. Use clean damp cloths to wipe the tool.
3. Check the state of all electrical cables.
4. Keep the motor air openings free of
oil, grease and sawdust or woodchips,
and store the tool in a dry place.
5. Be certain that all moving parts are well
lubricated with silicone or light oil spray,
particularly after lengthy exposure to
damp and/or dirty conditions. Do not use
grease, because it tends to attract and
hold sawdust.
WARNING:
WARNING:
WARNING: