Installation Instructions

Page 21
OPERATION
When using the clamp
included or a C-clamp (sold separately)
to secure the work piece; clamp the work
piece on one side of the blade ONLY. The
work piece MUST remain unclamped on
the other side of the blade to prevent the
blade from binding in the work piece. The
work piece binding the blade will cause
the motor to stall and cause kickback,
resulting in possible serious injury.
WORKLIGHT ON/OFF (FIG. 21)
Turn on the work light LED switch for
lighting in darker areas.
BEFORE starting any
cutting operation, clamp or bolt your
compound miter saw to a workbench or
at stable work surface. NEVER operate
your miter saw on the oor or in a
crouched position. Failure to heed this
warning could result in serious personal
injury.
WARNING:
FIG. 21
WARNING:
HOW TO USE THE DUAL
LASER LINE (FIG. 22)
1. Mark your work piece with a pencil line
at the point to be cut.
2. Push the Laser ON/OFF switch to “ON”
to activate the dual laser line. Align your
pencil line in the middle of the dual laser
lines.
4. Clamp your work piece in place using
the hold-down clamp.
5. Follow all of the cutting instructions for
the type of cut to be performed.
ON/OFF SWITCH
For safety, the ON/OFF switch is designed
to prevent accidental starts. To operate the
safety switch, press the Lock-off button
to disengage the lock, and then pull the ON/
OFF trigger switch and release the Lock-off
button (Fig. 23).
When the ON/OFF trigger switch is released,
the Lock-off button will engage the safety
switch automatically.
FIG. 22
Worklight