Installation Instructions

ManualsBrandsPerformax ManualsMiter Saws15-Amp Corded 10" Single-Bevel Sliding Compound Miter Saw

BEVEL-ANGLE INDICATOR

ADJUSTMENT (IF NECESSARY)

(FIG. 12)

1. Unplug the saw.

2. Check to see if the bevel-angle

indicator is pointing to 0° on the bevel

scale.

3. If the indicator is not pointing to 0°,

loosen the bevel-angle indicator screw,

adjust the indicator to 0° on bevel-angle

scale, and then retighten the screw.

Page 16

To loosen the bevel lock lever tension:

If the bevel locking lever is in the upper un-

locked position and the miter saw head will

not bevel, then perform the tension loosen-

ing steps shown below.

1. Start from the unlocked position (Lift up

the lever see g.11a)

2. Pull the lever towards you.(See g.11b)

3. Push the lever down. (Fig.11c)

4. Release the lever. (Fig.11d)

NOTICE: The lever should automatically

snap back. If it does not snap back, move

the lever up and down slightly until it releas-

es and snaps back.

5. Lift up the bevel lever. (Fig.11e)

ASSEMBLY

FIG. 11

FIG. 10a FIG. 11b

FIG. 11a

FIG. 10b FIG. 11c

FIG. 10c FIG. 11d

FIG. 10d FIG. 11e

FIG. 10e

FIG. 12