Installation Instructions

Page 14
ASSEMBLY
5. If the blade is not 90° to the fence,
completely unscrew the fence locking
knob and remove the fence extensions.
6. Loosen the four hex-head bolts (Fig. 4)
and rotate the fence until the square is
ush along its entire length. Retighten
the hex-head bolts. Remount the fence
extensions.
NOTICE: If the saw has not been used
recently, verify that the blade is square to
the fence, and readjust if necessary.
MITER-ANGLE INDICATOR
ADJUSTMENT (IF NECESSARY)
(FIG. 5)
Failure to unplug your
saw could result in accidental starting
causing serious injury.
1. Unplug the saw.
2. Place the miter table at the zero
position, making sure the miter-detent
locking lever is secured in position.
3. Loosen the miter-angle indicator screw
and adjust the indicator to the “0” mark
on the miter scale (Fig. 5).
4. Tighten the miter-angle indicator screw.
SQUARING THE BLADE TO THE
TABLE (FIG. 6-8)
Failure to unplug your
saw could result in accidental starting
causing serious injury.
1. Unplug the saw.
2. Push the 0° stop pin to set the bevel
angle to 0° and lock it in place.
3. Lower the saw arm all the way, and hold
it down while pushing the locking pin to
lock the saw arm in the “DOWN” position.
4. Place a combination square on the
miter table with the rule against the table
and heel of the square against the saw
blade.
NOTICE: Be sure to rest the square
against the body of the blade, and not
against the teeth of the blade.
FIG. 5
WARNING:
WARNING:
FIG. 6
FIG. 7
0° Stop pin