Installation Instructions

Page 12
SPECIFICATIONS
Motor 15 AMP, 120V~60Hz
No-load Speed 5,000 RPM
Blade 10" (25.4 cm) (40-tooth)
Arbor Size 5/8" (15.9 mm)
Laser 635 nm, ≤1 mW, Class II
Sliding Length 8" (205 mm)
Base width 18-1/2" (47 cm) without extension table
Cutting Capacity
90° Crosscut 3-1/2" x 12"
45° Miter cut 3-1/8" x 8-3/8"
45° Bevel cut 1-3/4" x 12"
45° Miter/Bevel cut 1-3/4" x 8-3/8"
Weight 38 lbs. 9 oz. (17.5 kg)
OVERVIEW
Laser On/Off Switch: Press the laser switch
to turn the dual laser lines on and off.
Work light On/Off Switch: Press the work
light switch to turn the work light on and off.
On/Off trigger switch and safety lock-off
button: Press the Lock-off button to
disengage the lock, and then pull the ON/
OFF trigger switch to turn the saw on.
Miter-angle scale: marked in 1° increments,
from 0° to 50° left and 55° right. Positive miter
stops are positioned at 0°, 15°, 22.5°, 31.6°,
and 45° for exact cuts at these common
angles.
Bevel-angle scale: marked in 1° increments
from 0° to 48° left, with 30° marked. Positive
bevel stops are positioned at 0°, 33.9°, 45˚
and 48˚ for exact cuts at these common
bevels.
Miter locking knob: locks knob locks the
saw table at the desired miter angle,
0° to 50° left or 55° right.
Miter-detent Locking lever: locks or
releases the table from a miter detent.
Bevel Locking lever: securely locks your
compound miter saw at the desired bevel
angle.
NOTICE: It is necessary to specially adjust
the 48° left bevel angle.
Upper sliding fence/ Lower moveable
fence: adjusts for added precision.
Self-Retracting Lower Blade Guard: made
of shock-resistant, translucent plastic,
provides protection from each side of the
blade. It retracts over the upper blade guard
as the blade is lowered into the work piece.
Hold-down Clamp: may be on left or
right fence or base to securely clamp the
work piece.
Carrying Handle: For carrying and
transporting the saw.
Lock Pin