Use And Care Manual

WARNING! It is recommended

Two Position Adjustment (Fig.3)

The driver can be used as one

straight driver.

First press the rotation button,

turn the front section in an

anticlockwise direction and

then release the button when

can not turn it again.

NOTICE: Do not use screwdriver

as a pry bar in either

position.

CAUTION: To avoid screwdriver

being turned on accidentally, keep

switch locked in center position

Fig.3

Fig.4

Flash light (Fig.4)

Flash light

lens

Push on the lens to turn the light on;

Push on the lens again to turn it off.

that all the repair or replacement for this

tool shall be performed by a qualiﬁed service technician. Contact or visit the

nearest Menards store for more information.

WARNING! Always use only a soft, dry cloth to clean your screwdriver,

never use any detergent or alcohol.

Disconnect the power unit from the main supply before cleaning.

CAUTION! No chemical agents are approved for use in cleaning this power

tool. Clean with a dry cloth or towel only.

MAINTENANCE

The center position of the switch

locks the tool in the “OFF” position.

When changing the position of the switch, be sure the trigger is is not

depressed.