Use And Care Manual

7
On/Off trigger switch. To turn tool on, press the trigger switch. To turn the
tool off, release the trigger switch.
Forward/Reverse switch. The forward/reverse switch should only be
operated when the motor is NOT running.
Worklight. For working in dark spaces.
Allows end user to know when to charge tool
LED Battery Capacity Indicator.
Flash light switch. For low-light situations.
Two Position Adjustment Switch .
Adjustable 2-position handle allows for operation in either in-line or pistol-grip.
TO CHARGE
Make sure your screwdriver has completely stopped before attempting to
charge it. Insert the power unit jack into charging socket, making sure they
are properly connected.
ACCESSORIES
Power unit can be used with normal house voltage of 120 volts, 60 Hz, AC
only.
2. Connect the power unit to the power supply.
3. During the charge, the battery indicator (red light) will turn on.
1. After normal usage, the battery requires approximately 3-5 hours charging
time to reach full capacity.
4. After 3-5 hours charging time, pull out from power supply and start the
screwdriver, if 3 battery indicator lights are on, the screwdriver is full
charged.
OPERATION
Phillips driver bits ................................................................................................3 pcs
Torsion bits .......................................................................................................... 3 pcs
Slotted driver bits ............................................................................................... 3 pcs
Square driver bits............................................................................................... 2 pcs
Magnetic bit holder ............................................................................................ 1 pc
Charger .................................................................................................................. 1 pc