Installation Instructions

Page 10
OPERATION
PIVOTING THE SHOE (FIG.4)
The shoe pivots to provide maximum control
against the surface being cut.
1. Unplug the reciprocating saw from the
power supply.
2. Hold the saw firmly, and then pivot the
shoe to the desired angle.
FIG. 4
Pivot shoe
LED WORKLIGHT (FIG.5)
The LED worklight, located next to the
tool-less blade clamp of this tool, will
illuminate when the saw is turned on. This
provides additional light on the surface of
the workpiece for operation in lower-light
conditions. The LED worklight will turn off
when the saw is turned off.
FIG. 5
LED worklight
TURNING ON AND OFF (FIG.6)
1. Connect the power cord of your
reciprocating saw to a standard
household power outlet.
2. To turn the saw ON, depress the
variable-speed trigger switch.
3. To turn the tool OFF, release the trigger
switch.
This tool has a variable-speed trigger
switch that delivers higher speed with
increased trigger pressure and lower speed
with decreased trigger pressure. Speed is
controlled by the degree to which the trigger
is depressed.
WARNING:
Before plugging in the
tool, always check to determine that the
switch performs properly and returns to
the “OFF” position when released.
FIG. 6
Variable-speed
trigger switch