Technical Specifications

Page 14
“LIVE TOOL INDICATOR” LIGHT
(FIG. 10)
Your router also has a “live tool indicator”
green light, located on the motor housing
top cap where the power cord enters the
motor housing. This green light is always
on when the router motor is plugged into a
power source.
FIG. 10
Live tool indicator
STRAIGHT-EDGE GUIDE
(FIG. 11)
This edge guide can be used as an aid in
routing applications such as decorative
edging, straight edge planning and trimming,
grooving, dadoing and slotting.
To attach the edge guide to the xed base,
simply insert the edge-guide rods into the
edge-guide mounting slots either from the
left or the right. Adjust the edge guide to the
desired position, and then secure the edge
guide by turning the lock knobs clockwise.
OPERATION
FIG. 11
ELECTRONIC VARIABLE SPEED
CONTROL (FIG. 12)
The electronic speed control feature allows
the motor speed to be matched to the cutter
size and material for an improved nish and
extended bit life.
Speed changes are made starting at “1” and
rotating the speed control dial clockwise
increase the speed, and counter-clockwise
to decrease the speed as indicated on the
Dial, numbered 1 through 6.
FIG. 12
Variable-speed dial
NOTICE: The speed may be changed while
the router is “ON”, but do not change the
speed if the cutter bit is in the workpiece.
WARNING:
Before operating your
router, follow all safety instructions in this
manual. Failure to do so could result in
serious personal injury.