User Manual

10
LOCKING PIN
PACKAGE CONTENTS
PARTS LIST
ITEM # Description Qty.
1. Frame Base 1
2. Ram 1
3. Ram Support 1
4. Safety Bar 1
5. Washer’s 4
6. Hex Screw 1
7. Return Spring 1
8. Pump Pedal 1
9. Leveling bolt’s 2
10. Handle 1
11. Universal tie down’s 4
The following tools (not included) are needed to assemble:
17mm & 19mm wrench or socket, 5mm & 6mm hex key, Phillips screwdriver.
1
2
6
3
4
7
9
10
8
5
11
ASSEMBLY INSTRUCTIONS
2
1
1. Remove hex screws from frame base (1) and use
them to attach Hydraulic ram (2). Ensure that the
release lever on the ram is positioned facing away
from the loading surface.
Tighten hex screws with
a 6mm hex key.
ASSEMBLY CONT.
9. To attach Handle (10), remove
locking pin with ring from Ram
Support (3) and insert handle into
hole. Align the holes on the handle
with the holes on the ram support
and fasten with locking pin.
OPERATION
SPECIFICATIONS
Lift Range 4-3/4” to 16-1/2”
Maximum Load 1,250 lbs.
Clearance 4-3/4”
Dimensions (without handle) 36” X 15-1/2” X 15-1/2”
Load Surface 13-1/4” X 14-1/2”
11
1. To lower the Multi-Purpose Lift, gently
depress the valve release lever located on
the bottom left side of the hydraulic ram.
If the jack is lifted high enough that the safety bar
is engaged, the jack must be raised higher to
allow the safety lever to disengage in order
to lower the jack
2. Position the jack under the load to be lifted
while in the fully down position.
3. Turn leveling bolts clockwise until the
wheels nearest the leveling bolts are
slightly off the ground.
4. To raise the lift,
repeatedly depress on the
pump pedal until the load has reached desired height.
To avoid accidental lowering, ensure that the
safety levers engage into the slots built into
the frame base. Gently depress the lowering
lever to allow the safety levers to lock into place.
5. Use the universal tie downs (11) included
with your multi-purpose lift to secure the load.
Anchors are located at each corner of the lift.
Place vinyl covered hooks on anchors and solid
non-moving part on top of load. Thread web
through cam buckle and pull tight. Hooks and
buckles must be in line with direction of pull.
Loop straps are also provided to prevent
scratching of the lifted item. Secure loop straps
to load and connect to tie down before
pulling tie down tight.
6 3