User Manual

INSUFFICIENT POWER:
Probable Cause Solution
Dirty or clogged air passages......... Flush and lubricate tool, drain air tank and supply line
Insufficient air supply ...................... Increase line pressure, Make sure compressor
matches tool's air pressure and consumption needs
Air leakage ...................................... Use PTFE tape at all fittings and joints. Check tool for
worn or damaged O-rings & seals.
Worn/damaged wear & tear parts .. Replace as necessary.
Tool matching ................................. Be sure you are using a tool suited for the torque
requirements of the job at hand.
TROUBLESHOOTINGPARTS LIST
INDEX DESCRIPTION QTY INDEX DESCRIPTION QTY
1 Hex Cap Screw 8
2 Spring Gasket 8
3 Hammer Case 1
4 Anvil Bushing 1
5 Circlip 1
6 O-Ring 1
7 Anvil 1
8 Hammer 2
9 Hammer Cage 1
10 Hammer Pin 2
11 Gasket 1
12 Bearing 1
13 Front End Plate 1
14 Vane 6
15 Rotor 1
16 Pin 2
17 Cylinder 1
18 Pin 1
19 Rear End Plate 1
20 Bearing 1
21 Gasket 1
22 Trigger 1
23 Pin 2
24 Inlet Gasket 1
25 Rubber Gasket 1
26 Air Inlet Valve 6
27 Spring 1
28 Air Inlet Screen 1
29 Air Inlet 1
30 O-Ring 1
31 Plastic Cover 1
32 Handle 1
33 Throttle Bushing 1
34 Steel Ball 1
35 Spring 1
36 Throttle Core 1
37 O-Ring 1
38 Button 1
39 Screw 1
40 Back Cover 1
41 Gasket 1