User's Manual

received, including interference that may cause undesired operation.
(1) This device may not cause harmful interference, and (2) this device must accept any interference
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
Preliminary User Manual Draft – Not for Mass Production
FCC STATEMENTS:
CAUTION:
Changes or modifications to this equipment not expressly approved by the manufacturer could void the user’s
authority to operate the equipment.
The equipment complies with FCC RF exposure limits set forth for an uncontrolled environment. The equipment
must not be co-located or operating in conjunction with any other antenna or transmitter.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of
the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
INDUSTRY CANADA STATEMENTS:
. Operation is subject to the following two
conditions:
(1) this device may not cause interference, and
(2) this device must accept any interference, including interference that may cause undesired operation of the
device.
The device meets the exemption from the routine evaluation limits in section 2.5 of RSS 102 and compliance
with RSS-102 RF exposure, users can obtain Canadian information on RF exposure and compliance.
"Le present appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de
licence.
L'exploitationestautorisée aux deux conditions suivantes:
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareildoit accepter tout brouillage radio électrique subi, mêmesi le brouillage est
susceptible d'encompromettre le fonctionnement.”
Regulatory Statements
This device complies with Industry Canada's licence-exempt RSSs.