Full Product Manual

- 7 -
STEP 1: Wheel Assembly
1. Attach the wheels(#4) to the oil tank axle secure using flat washerØ20(#6), thin hex slotted
nut M20(#8) and cotter pin Ø4x36 (#5).Place plastic cover which in the blue bag on the axle
cap then install the axle cap (#7) on the end using rubber hammer.
STEP 2: Attach Tow Bar
1. Pull open the safety pin on the support leg, then lay down the support leg.
2. Attach the tow bar B (#2) to the tow bar A (#62) and secure using hex bolt M10x70 (#73), flat
washerØ10 (#22) and nylon lock nut M10 (#74).
Assembly Instructions
WARNING: After the slotted nut is
tightened, turn back 1/4 circle to make
sure the wheel can rotate smoothly
and freely. Failure to turn the slotted
nut back will cause the wheel not to
operate correctly.