Full Product Manual

- 8 -
STEP 3: Attach the Beam Assembly
1. Connect the Beam (#16) and Oil Tank using Hitch Pin (#17), then lock the Hitch Pin (#17)
using R Pin (#20).
STEP 4: Attach Engine to Mounting Plate
1. Place the polyurethane block (#53) and large flat washer Ø10 (#56) between the mounting
plate and engine.
2. Position the engine (#32) over the blocks and secure it to the mount plate put the hex bolt
M10x70 (#44) through the bottom of the plate (bolt should go through blocks, flat washer and
engine base). Place a flat washer Ø10 (#75), lock washer Ø10 (#74) and tighten the nylon lock
nut M10 (#73)
3. Attach the clear oil pipe (#51) to the bottom of the gear pump and secure with clamp (#49).