Full Product Manual

- 8 -
STEP 4: Attach Engine to Mounting Plate
1. Place the polyurethane block (#55) and large flat washer Ø10 (#58) between the mounting
plate and engine.
2. Position the engine (#33) over the blocks and secure it to the mount plate put the hex bolt
M8x65 (#46) through the bottom of the plate (bolt should go through blocks, flat washer and
engine base). Place a flat washer Ø8 (#36), lock washer Ø8(#32) and tighten the nylon lock
nut M8 (#31)
3. Attach the clean oil pipe (#53) to the bottom of the gear pump and secure with clamp (#51).
STEP 5: Attach Hydraulic Hose
1. Put O ring Ø11.2x2.4 (#19) on the gear pump connector (#23), and attach the hydraulic hose
(Connector-valve) (#16) to the gear pump connector (#23).
2. Put the O ring Ø17x2.5 (#71) on the connector (#50), and attach the hydraulic hose (#7) to the
end of the connector (#50).
Lock in this place.