Full Product Manual

- 9 -
STEP 8: Connect the Right and Left Sides of the Worktable
1. Fix the worktables to the front bracket using inner hex round head screw M10x25(x5), flat
washer Ø10(x5), lock washerØ10(x5) and nylon lock nut M10(x5).
2. Connect the right and left sides of the worktable using the table-board connecting plate(x1),
inner hex countersunk head screw M8x20(x4), flat washer Ø8(x4) and nylon lock nut M8(x4),
ensuring the oval holes at the table-board connecting plate is upward.
3. TIGHTEN ALL HARDWARE FROM STEP 6 TO 8.
STEP 9: Connect the Tow Bar
1. Connect the tow bar to the front support leg using hex bolt M10x30(x2), flat washer Ø10(x2),
lock washerØ10(x2) and nylon lock nut M10(x2).
When the splitter is not being
towed. Attach the bar under
the table for ease of operation.
Make sure the
oval holes at the
table-board
connecting plate
are upward.