Full Product Manual

- 16 -
No. Problem Cause Solution
1
Engine will not start
1. Check gas level
2. Check oil level
3. Check fuel ON/OFF
4. Check ON/OFF switch
1. Add gasoline
2. Add oil
3. Reference engine manual
2
Push plate cannot
retract or retracts
slowly
1.Wood Chips or Debris under
push plate
2. Retract spring too loose.
1. Remove debris from the
push plate
2. Lubricate oil on the beam.
3. Adjust or replace retract
spring.
3
Push plate retract
too fast
Retract spring too tight. Adjust or replace retract
spring.
4
No force or little
force during splitting
1. #57 Round Nut M40x1.5 is
loose
2. Clutch spring deformed
1. Enlarge the clearance and
tight the #57 Round Nut
M40x1.5.
2. Replace the clutch spring
5
Noise from
engagement clutch
1. Clutch clearance is too small
2. Clutch is not completely
disengaged
Adjust the clutch clearance
or replace clutch spring
(See the website for
instruction)
Troubleshooting