Full Product Manual

- 10 -
STEP 10: Attach Outer Housing
Note: Leave all inner hex round head screws loose until the parts are installed in steps 10
and 11.
1. Attach threaded rod into the holes in the wheel stand and tighten.
2. Attach outer housing using inner hex round head screw M6x20(x4), lock washer Ø6(x4) and
large flat washer Ø6(x4).
STEP 11: Attach the End Cover and Handle
1. Attach the end cover to the beam using inner hex round head screw M6x20(x2), lock washer
Ø6(x2) and large flat washer Ø6(x2).
2. Attach the action handle to the handle connecting plate, then fixed with inner hex round head
screw M6x20(x2), lock washer Ø6(x2).
3. Attach operation handle to the handle assembly and tighten all hardware.