Installation Guide

0721_LVF_SN_Install P.1

Vinyl Stair Nose Molding Installation

The Performance Accessories Vinyl Flush Mount Stair nose is a moisture proof molding

that is suitable to nish step downs and stair installations of luxury vinyl ooring. The

Performance Accessories Vinyl Flush Mount Stair nose is designed for versatility and

beauty. One molding can accommodate a wide range of oor thicknesses, from 2mm

up to 7.5mm in thickness. The width of the stair nose provides a more polished nished

stair tread than other products. The longer length will accommodate more stairs and

can be used on bull-nosed and squared-nosed stair installations. Just follow these

simple steps.

78¾ in · 2m

Overlap without Shim

Flooring

Flush Mount with Shim

Flooring

Shim

1. Measure and trim to t

• For ush installation, install matching shim to the edge of the stair tread

• A shim is not required for overlap installation

PAGE 1
Vinyl Stair Nose Molding Installation The Performance Accessories Vinyl Flush Mount Stair nose is a moisture proof molding that is suitable to finish step downs and stair installations of luxury vinyl flooring. The Performance Accessories Vinyl Flush Mount Stair nose is designed for versatility and beauty. One molding can accommodate a wide range of floor thicknesses, from 2mm up to 7.5mm in thickness. The width of the stair nose provides a more polished finished stair tread than other products.
PAGE 2
Vinyl Stair Nose Molding Installation 2. Apply polyurethane adhesive to underside • “S” shaped bead on ribbed surface of nosing • Straight bead under stand-oﬀ elbow 3. Carefully position the trim and press down firmly along the entire stair nose Flush Mount with Shim Overlap without Shim 4. Let adhesive cure for at least 4 hours before walking on it. Wait 24-48 hours for full traﬃc exposure 0721_LVF_SN_Install P.