Instructions / Assembly

6
OPERATING THE UNIT
POSITIONING THE UNIT
A dehumidier operating in one room will have little or no eect in
drying an adjacent enclosed area, such as a closet, or other room
unless there is adequate circulation of air around the area.
• Do not use outdoors.
• This dehumidier is intended for indoor residential applications
only. This dehumidier should not be used for commercial or
industrial applications.
• Place the dehumidier on a smooth, level oor, strong enough
to support the unit with a full bucket of water.
• Allow at least 8 in. (20 cm) of air space all around the unit for
proper air circulation 16” or more from the top of the unit.
• Place the unit in an area where the temperature will not fall
below 41°F (5°C). The coils can become covered with frost at
temperatures below 41°F (5°C), which may reduce performance
and cause an error code.
• Place the unit away from the clothes dryer, heater
or radiator.
• Use the dehumidier to prevent moisture damage anywhere books
or valuables are stored.
• Use the dehumidier in a basement to help prevent
moisture damage.
• The dehumidier must be operated in an enclosed area to be
most eective.
• Close all doors, windows and other outside openings in the space
that you wish to dehumidify.
WHEN USING THE UNIT
A dehumidier operating in one room will have little or no eect in drying an adjacent enclosed area, such as a closet, or
other room unless there is adequate circulation of air entering and exiting the area.
• WHEN FIRST USING THE DEHUMIDIFIER, OPERATE THE UNIT ON “CONTINUOUS” MODE FOR 24 HOURS.
NOTE: After the rst 24 hours, should you wish to set a desired humidity, you will need to take the unit o of
CONTINUOUS. You will not be able to select a desired humidity while the unit is set on CONTINUOUS mode.
• This unit is designed to operate in a working environment between 41°F/5°C and 95°F/35°C.
• If the unit has been switched o and needs to be switched on again quickly, allow approximately 3 minutes for the
correct operation to resume.
• DO NOT connect the dehumidier to a multiple socket outlet that is being used for other electrical appliances.
• Select a suitable location, making sure you have easy access to an electrical outlet.
• Plug the unit into an electrical outlet with a grounding connection.
• Make sure the water bucket is correctly tted or the unit will not operate properly.
• NOTE: DO NOT attempt to move the dehumidier when there is water in the bucket. The unit may tip over and spill water
or damage unit.
8ʺ or more
16ʺ or more
Air intake
grille
Air outlet
grille
8ʺ or
more
8ʺ or
more
8ʺ or
more
FIG. 6