Operation Manual

EDB5
V. 02 – 12/11/2013 4 ©Velleman nv
5. Overview
Refer to the illustrations on page 2 of this manual.
1
status LED
4
CODE button
2
speaker
5
melody select button (SEL)
3
belt/clip mounting hole
6
battery compartment
A
screw (behind name tag)
C
push button
B
status LED
D
mounting holes
6. Operation
1. Make sure batteries are present inside the doorbell and doorbell
pushbutton (see §8).
2. Mount the doorbell pushbutton in a location where it is protected
from harsh weather conditions (IP44).
3. Press and hold the CODE button [4] for ± 3 seconds until status
LED [1] flashes. Within 15 seconds, press the doorbell push
button [C] to set the transmitting code.
4. Mount the doorbell itself in a dry indoor location. It can also be
carried around when desired.
Note: normal range without obstructions is ± 40 m. Walls, metal
frames and some appliances (e.g. working microwave ovens,
radios…) will reduce this range.
5. Press the melody select button [5] to select the desired melody
(4 options).
7. Troubleshooting
When sound becomes weak, replace the batteries of the doorbell
(see §8).
When pushing a push button does not produce a chime:
o verify whether the push button is located within the specified
range (max. 40 m). If not, bring it closer to the doorbell.
o verify whether doorbell and doorbell push button are not
surrounded by metal or near a strong magnetic field. In these
cases, move the push button or doorbell to a suitable location.
o replace the push button battery (see §8).
8. Batteries
Doorbell
1. Open the battery compartment [6].
2. Insert 2 new 1.5 V batteries type AA (LR6C) with polarity as
indicated inside the battery casing.
3. Close the battery compartment.