User's Manual

Card

SIM card slots here.

Remote SIM

Settings

If “Use Remote SIM Only” is selected in the SIM card section, the Remote SIM Settings will

be shown.

You may need to enable the remote SIM Host settings in the Remote SIM management, see

the section 13.14.7 or Appendix C for more details on FusionSIM. After that, click on “Scan

nearby remote SIM server” to show the serial number(s) of the connected SIM Injector(s).

If you want to select a specific SIM, in the Cellular Settings, type “:” and then the number of

the SIM slot, eg.1111-2222-3333:7.

LTE/3G

This drop-down menu allows restricting cellular to particular band. Click the button to

enable the selection of specific bands.

Optimal Network

Discovery

Cellular WAsN by default will only handover from 3G to LTE network when there is no active

data traffic, enable this option will make it run the handover procedures after fallback to 3G for

a defined effective period, even this may interrupt the connectivity for a short while.

Band Selection

When set to Auto, band selection allows for automatically connecting to available, supported

bands (frequencies) .

When set to Manual, you can manually select the bands (frequencies) the SIM will connect to.

Data Roaming

This checkbox enables data roaming on this particular SIM card. When data roaming is

enabled this option allows you to select in which countries the SIM has a data connection.

The option is configured by using MMC (country) codes.Please check your service provider’s

data roaming policy before proceeding.

Authentication

Choose from PAP Only or CHAP Only to use those authentication methods exclusively.

Select Auto to automatically choose an authentication method.

Operator

Settings

This setting allows you to configure the APN settings of your connection. If Auto is selected,

the mobile operator should be detected automatically. The connected device will be

configured and connection will be made automatically. If there is any difficulty in making

connections, you may select Custom to enter your carrier’s APN, Login, Password, and

Dial Number settings manually. The correct values can be obtained from your carrier. The

default and recommended setting is Auto.

https://www.peplink.com