User's Manual
Table Of Contents
- Introduction and Scope
- Glossary
- 1 Product Features
- 2 Overview
- 3 Installation
- 4 Connecting to the Web Admin Interface
- 5 SpeedFusion Cloud
- 6 Configuring the LAN Interface(s)
- 7 Configuring the WAN Interface(s)
- 8 Advanced Wi-Fi Settings
- 9 ContentHub Configuration
- 10 MediaFast Configuration
- 11 Bandwidth Bonding SpeedFusionTM / PepVPN
- 12 IPsec VPN
- 13 Outbound Policy Management
- 14 Inbound Access
- 15 NAT Mappings
- 16
- 17 Firewall
- 20 Remote User Access
- 21 Miscellaneous Settings
- 22 AP - access point
- 24 AP Controller Status
https://www.peplink.com
146
Copyright @ 2020 Pepwave
GPIO Menu
The Ignition Sensing options are available in Advanced > GPIO
The configurable option for Ignition Input is Delay; the time in seconds the router stays
powered on after the ignition is turned off.
Still under development:
O/P (connected to I/O pin on 4 pin connector) can be configured as a digital input, digital output
or analog input.
Digital Input - the connection supports input sensing; it reads the external input and determine
if the settings should be 'High' (on) or 'Low' (off).
Digital Output - when there is a healthy WAN connection, the output pin is marked as 'High' (on).
Otherwise, it will be marked as 'Low' (off).
Analog Input - to be confirmed. In most cases should read the external input and determine the
voltage level.