Users Manual
https://www.peplink.com 137 Copyright @ 2021 Peplink
This feature allows you to change the local ID of a PepVPN connection. Click the button to select your
connection and the following menu will appear:
After updating the local ID, click Save to store your changes.
Link Failure Detection
Link Failure
Detection Time
The bonded VPN can detect routing failures on the path between two sites over each WAN
connection. Failed WAN connections will not be used to route VPN traffic. Health check
packets are sent to the remote unit to detect any failure. The more frequently checks are sent,
the shorter the detection time, although more bandwidth will be consumed.
When Recommended (default) is selected, a health check packet is sent every five seconds,
and the expected detection time is 15 seconds.
When Fast is selected, a health check packet is sent every three seconds, and the expected
detection time is six seconds.
When Faster is selected, a health check packet is sent every second, and the expected
detection time is two seconds.
When Extreme is selected, a health check packet is sent every 0.1 second, and the expected
detection time is less than one second.
Important Note
Peplink proprietary SpeedFusion
TM
uses TCP port 32015 and UDP port 4500 for establishing VPN connections. If you
have a firewall in front of your Peplink Balance devices, you will need to add firewall rules for these ports and protocols
to allow inbound and outbound traffic to pass through the firewall.
SpeedFusion:ProfileConfiguration
Click the New Profile button, or click one of the existing profiles, and the following menus will appear: