User's Manual

https://www.peplink.com 29 Copyright @ 2019 Peplink
Band Selection
When set to Auto, band selection allows for automatically connecting to available, supported
bands (frequencies) .
When set to Manual, you can manually select the bands (frequencies) the SIM will connect to.
Data Roaming
This checkbox enables data roaming on this particular SIM card. When data roaming is
enabled this option allows you to select in which countries the SIM has a data connection.
The option is configured by using MMC (country) codes.Please check your service provider’s
data roaming policy before proceeding.
Authentication
Choose from PAP Only or CHAP Only to use those authentication methods exclusively.
Select Auto to automatically choose an authentication method.
Operator
Settings
This setting allows you to configure the APN settings of your connection. If Auto is selected,
the mobile operator should be detected automatically. The connected device will be
configured and connection will be made automatically. If there is any difficulty in making
connections, you may select Custom to enter your carrier’s APN, Login, Password, and
Dial Number settings manually. The correct values can be obtained from your carrier. The
default and recommended setting is
Auto
.
APN / Login /
Password /
SI
M PIN
When Auto is selected, the information in these fields will be filled automatically. Select
Custom to customize these parameters. The parameter values are determined by and can be
obtained from the ISP.
Bandwidth
Allowance
Monitor
Check the box Enable to enable bandwidth usage monitoring on this WAN connection for
each billing cycle. When this option is not enabled, bandwidth usage of each month is still
being tracked but no action will be taken.
Action
If email notification is enabled, you will be notified by email when usage hits 75% and 95% of
the monthly allowance. If Disconnect when usage hits 100% of monthly allowance is
checked, this WAN connection will be disconnected automatically when the usage hits the
monthly allowance. It will not resume connection unless this option has been turned off or the
usage has been reset when a new billing cycle starts.
Start Day
This option allows you to define which day of the month each billing cycle begins.
Monthly
Allowance
This field is for defining the maximum bandwidth usage allowed for the WAN connection each
month.
Signal Threshold Settings