Users Manual

https://www.peplink.com

104

Click Add Rule to display the following screen:

Rules are matched from top to bottom. If a connection matches any one of the upper rules,

the matching process will stop. If none of the rules match, the Default rule will be applied. By

default, the Default rule is set as Allow for both outbound and inbound access.

Inbound / Outbound Firewall Settings

Rule Name

This setting specifies a name for the firewall rule.

Enable

This setting specifies whether the firewall rule should take effect. If the box is

checked, the firewall rule takes effect. If the traffic matches the specified

protocol/IP/port, actions will be taken by the Pepwave router based on the other

parameters of the rule. If the box is not checked, the firewall rule does not take

effect. The Pepwave router will disregard the other parameters of the rule.

Click the dropdown menu next to the checkbox to place this firewall rule on a time

schedule.

WAN Connection

(Inbound)

Select the WAN connection that this firewall rule should apply to.

Protocol

This setting specifies the protocol to be matched. Via a drop-down menu, the

following protocols can be specified:

● TCP

● UDP

● ICMP

● IP