Installation Instructions

https://www.peplink.com
188
Copyright @ 2019 Pepwave
The availability of some specific channels and/or operational frequency bands are
country dependent and are firmware programmed at the factory to match the intended
destination.
3. Industry Canada statement:
This device complies with ISED’s licence-exempt RSSs. Operation is subject to the following
two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
Le présent appareil est conforme aux CNR d’ ISED applicables aux appareils radio exempts
de licence.
L’exploitation est autorisée aux deux conditions suivantes : (1) le dispositif ne doit pas
produire de brouillage préjudiciable, et (2) ce dispositif doit accepter tout brouillage reçu, y
compris un brouillage susceptible de provoquer un fonctionnement indésirable.
For licence-exempt equipment with detachable antennas, the user manual shall also contain
the following notice in a conspicuous location:
This radio transmitter 20682-P1941 has been approved by Innovation, Science and Economic
Development Canada to operate with the antenna types listed below, with the maximum
permissible gain indicated. Antenna types not included in this list that have a gain greater than
the maximum gain indicated for any type listed are strictly prohibited for use with this device.
WIFI Antenna type: Replacement Antenna
WIFI Antenna gain: 2.4GHz / 2.44 dBi , 5GHz / 4.73 dBi
LTE Antenna type: Replacement Antenna (04-410055-00)
LTE Antenna gain: 4 dBi
LTE Antenna type: Replacement Antenna (04-410093-01)
LTE Antenna gain: 4.38 dBi
Radiation Exposure Statement:
This equipment complies with ISED radiation exposure limits set forth for an uncontrolled
environment.
This equipment should be installed and operated with greater than 23 cm between the radiator
& your body.