User's Manual
Table Of Contents
- 1 Introduction and Scope
- Glossary
- 2 Product Features
- 3 Pepwave MAX Mobile Router Overview
- 4 Advanced Feature Summary
- 5 Installation
- 6 Mounting the Unit
- 7 Connecting to the Web Admin Interface
- 8 Configuring the LAN Interface(s)
- 9 Configuring the WAN Interface(s)
- 10 Advanced Wi-Fi Settings
- 11 ContentHub Configuration
- 12 MediaFast Configuration
- 13 Bandwidth Bonding SpeedFusionTM / PepVPN
- 14 IPsec VPN
- 15 Outbound Policy Management
- 16 Inbound Access
- 17 NAT Mappings
- 18 QoS
- 19 Firewall
- 22 Remote User Access
- 23 Miscellaneous Settings
- 24 AP - access point
- 26 AP Controller Status
- 27 Toolbox
- 28 System Settings
- 29 Tools
- 30 Status
- Appendix A: Restoration of Factory Defaults
- Appendix B: Declaration
https://www.peplink.com
Copyright @ 2021 Pepwave
8 Configuring the LAN Interface(s)
8.1 Basic Settings
LAN interface settings are located at Network>LAN>Network Settings. Navigating to that
page will show the following dashboard:
This represents the LAN interfaces that are active on your router (including VLAN). A grey “X”
means that the VLAN is used in other settings and cannot be deleted. You can find which
settings are using the VLAN by hovering over the grey “X”.
Alternatively, a red “X” means that there are no settings using the VLAN. You can delete that
VLAN by clicking the red “X”
Clicking on any of the existing LAN interfaces (or creating a new one) will show the following :
IP Settings
IP Address
The IP address and subnet mask of the Pepwave router on the LAN.