User's Manual
Table Of Contents
- 1 Introduction and Scope
- Glossary
- 2 Product Features
- 3 Pepwave MAX Mobile Router Overview
- 4 Advanced Feature Summary
- 5 Installation
- 6 Mounting the Unit
- 7 Connecting to the Web Admin Interface
- 8 Configuring the LAN Interface(s)
- 9 Configuring the WAN Interface(s)
- 10 Advanced Wi-Fi Settings
- 11 ContentHub Configuration
- 12 MediaFast Configuration
- 13 Bandwidth Bonding SpeedFusionTM / PepVPN
- 14 IPsec VPN
- 15 Outbound Policy Management
- 16 Inbound Access
- 17 NAT Mappings
- 18 QoS
- 19 Firewall
- 22 Remote User Access
- 23 Miscellaneous Settings
- 24 AP - access point
- 26 AP Controller Status
- 27 Toolbox
- 28 System Settings
- 29 Tools
- 30 Status
- Appendix A: Restoration of Factory Defaults
- Appendix B: Declaration
https://www.peplink.com
Copyright @ 2021 Pepwave
28 System Settings
28.1 Admin Security
There are two types of user accounts available for accessing the web admin: admin and user.
They represent two user levels: the admin level has full administrative access, while the
user level is read-only. The user level can access only the device's status information; users
cannot make any changes on the device.
A web login session will be logged out automatically when it has been idle longer than the Web
Session Timeout. Before the session expires, you may click the Logout button in the web
admin to exit the session.
0 hours 0 minutes signifies an unlimited session time. This setting should be used only in
special situations, as it will lower the system security level if users do not log out before closing
the browser. The default is 4 hours, 0 minutes.
For security reasons, after logging in to the web admin Interface for the first time, it is
recommended to change the administrator password. Configuring the administration interface
to be accessible only from the LAN can further improve system security. Administrative settings
configuration is located at System>Admin Security.