User's Manual
Table Of Contents
- 1 Introduction and Scope
- Glossary
- 2 Product Features
- 3 Pepwave MAX Mobile Router Overview
- 4 Advanced Feature Summary
- 5 Installation
- 6 Mounting the Unit
- 7 Connecting to the Web Admin Interface
- 8 Configuring the LAN Interface(s)
- 9 Configuring the WAN Interface(s)
- 10 Advanced Wi-Fi Settings
- 11 ContentHub Configuration
- 12 MediaFast Configuration
- 13 Bandwidth Bonding SpeedFusionTM / PepVPN
- 14 IPsec VPN
- 15 Outbound Policy Management
- 16 Inbound Access
- 17 NAT Mappings
- 18 QoS
- 19 Firewall
- 22 Remote User Access
- 23 Miscellaneous Settings
- 24 AP - access point
- 26 AP Controller Status
- 27 Toolbox
- 28 System Settings
- 29 Tools
- 30 Status
- Appendix A: Restoration of Factory Defaults
- Appendix B: Declaration
https://www.peplink.com
Copyright @ 2021 Pepwave
21 BGP
Click the Advanced tab from the top bar, and then click the Routing Protocols>BGP item on
the sidebar to configure BGP.
Click "x" to delete a BGP profile
Click "Add" to add a new BGP profile
BGP
Name
This field is for specifying a name to represent this profile.
Enable
When this box is checked, this BGP profile will be enabled.
Otherwise, it will be disabled.
Interface
The interface where BGP neighbor is located
Autonomous
System
The Autonomous System Number (ASN) of this profile
Neighbor
BGP Neighbor's details
IP address
Neighbor's IP address
Autonomous
System
Neighbor's ASN
Multihop/TTL
Time-to-
live (TTL) of BGP packet.
Leave it blank if BGP neighbor is directly connected, otherwise you must specify a
TTL value. Accurately, this option should be used if the configured neighbor IP