User's Manual
Table Of Contents
- 1 Introduction and Scope
- Glossary
- 2 Product Features
- 3 Pepwave MAX Mobile Router Overview
- 4 Advanced Feature Summary
- 5 Installation
- 6 Mounting the Unit
- 7 Connecting to the Web Admin Interface
- 8 Configuring the LAN Interface(s)
- 9 Configuring the WAN Interface(s)
- 10 Advanced Wi-Fi Settings
- 11 ContentHub Configuration
- 12 MediaFast Configuration
- 13 Bandwidth Bonding SpeedFusionTM / PepVPN
- 14 IPsec VPN
- 15 Outbound Policy Management
- 16 Inbound Access
- 17 NAT Mappings
- 18 QoS
- 19 Firewall
- 22 Remote User Access
- 23 Miscellaneous Settings
- 24 AP - access point
- 26 AP Controller Status
- 27 Toolbox
- 28 System Settings
- 29 Tools
- 30 Status
- Appendix A: Restoration of Factory Defaults
- Appendix B: Declaration
https://www.peplink.com
Copyright @ 2021 Pepwave
RIPv2 Settings
Authentication
Choose an authentication method, if one is used, from this drop-
down menu.
Available options are MD5 and Text. Enter the authentication key next to the drop-
down menu.
Interfaces
Determine which interfaces this group will use to listen to and deliver RIPv2 packets.
OSPF & RIPv2 Route Advertisement
PepVPN Route
Isolation
Isolate PepVPN peers from each other. Received PepVPN routes will not be
forwarded to other PepVPN peers to reduce bandwidth consumption..
Network
Advertising
Networks to be advertised over OSPF & RIPv2. If no network is selected, all LAN /
VLAN networks will be advertised by default.
Static Route
Advertising
Enable this option to advertise LAN static routes over OSPF & RIPv2. Static routes
that match the Excluded Networks table will not be advertised.