Users Manual Part 1

https://www.peplink.com 74 Copyright @ 2018 Pepwave
button to enable the selection of specific bands.
Authentication
Choose from PAP Only or CHAP Only to use those authentication methods
exclusively. Select Auto to automatically choose an authentication method.
Data Roaming
This checkbox enables data roaming on this particular SIM card. Please check your
service provider’s data roaming policy before proceeding.
Operator Settings
This setting applies to 3G/EDGE/GPRS modems only. It does not apply to
EVDO/EVDO Rev. A modems. This allows you to configure the APN settings of your
connection. If Auto is selected, the mobile operator should be detected
automatically. The connected device will be configured and connection will be made
automatically. If there is any difficulty in making connection, you may select Custom
to enter your carrier’s APN, Login, Password, and Dial Number settings manually.
The correct values can be obtained from your carrier. The default and recommended
setting is Auto.
APN / Login /
Password /
SIM PIN
When Auto is selected, the information in these fields will be filled automatically.
Select Custom to customize these parameters. The parameter values are
determined by and can be obtained from the ISP.
Bandwidth
Allowance
Monitor
Check the box Enable to enable bandwidth usage monitoring on this WAN
connection for each billing cycle. When this option is not enabled, bandwidth usage
of each month is still being tracked but no action will be taken.
Action
If email notification is enabled, you will be notified by email when usage hits 75% and
95% of the monthly allowance. If Disconnect when usage hits 100% of monthly
allowance is checked, this WAN connection will be disconnected automatically when
the usage hits the monthly allowance. It will not resume connection unless this option
has been turned off or the usage has been reset when a new billing cycle starts.
Start Day
This option allows you to define which day of the month each billing cycle begins.
Monthly
Allowance
This field is for defining the maximum bandwidth usage allowed for the WAN
connection each month.
General Settings