Users Manual Part 1

https://www.peplink.com 52 Copyright @ 2018 Pepwave
PepVPN Profiles
to Bridge
The remote network of the selected PepVPN profiles will be bridged with this local
LAN, creating a Layer 2 PepVPN, they will be connected and operate like a single
LAN, and any broadcast or multicast packets will be sent over the VPN.
Spanning Tree
Protocol
Click the box will enable STP for this layer 2 profile bridge.
Override IP
Address when
bridge
connected
Select "Do not override" if the LAN IP address and local DHCP server should
remain unchanged after the Layer 2 PepVPN is up.
If you choose to override IP address when the VPN is connected, the device will
not act as a router, and most Layer 3 routing functions will cease to work.
DHCP Server Settings
DHCP Server
When this setting is enabled, the DHCP server automatically assigns an IP
address to each computer that is connected via LAN and configured to obtain an
IP address via DHCP. The Pepwave router’s DHCP server can prevent IP
address collision on the LAN.
IP Range &
Subnet Mask
These settings allocate a range of IP addresses that will be assigned to LAN
computers by the Pepwave router’s DHCP server.
Lease Time
This setting specifies the length of time throughout which an IP address of a
DHCP client remains valid. Upon expiration of the lease time, the assigned IP
address will no longer be valid and renewal of the IP address assignment will be
required.