Users Manual Part 1

https://www.peplink.com 100 Copyright @ 2018 Pepwave
data. If Default is selected, UDP port 4500 will be used. Port 32015 will be used if
the remote unit uses Firmware prior to version 5.4 or if port 4500 is unavailable. If
Custom is selected, enter an outgoing port number from 1 to 65535.
Bandwidth Limit
Define maximum download and upload speed to each individual peer. This
functionality requires the peer to use PepVPN version 4.0.0 or above.
Cost
Define path cost for this profile.
OSPF will determine the best route through the network using the assigned cost.
Default: 10
WAN
Smoothing
A
Select the degree to which WAN Smoothing will be implemented across your
WAN links.
Use IP ToS
Checking this button enables the use of IP ToS header field.
Latency
Difference Cutoff
Traffic will be stopped for links that exceed the specified millisecond value with
respect to the lowest latency link. (e.g. Lowest latency is 100ms, a value of 500ms
means links with latency 600ms or more will not be used)
A
- Advanced feature, please click the button on the top right-hand corner to activate.
To enable Layer 2 Bridging between PepVPN profiles, navigate to Network>LAN>Basic
Settings>*LAN Profile Name* and refer to instructions in section 9.1
8.41
WAN Connection Priority
WAN Connection
Priority
If your device supports it, you can specify the priority of WAN connections to be
used for making VPN connections. WAN connections set to OFF will never be
used. Only available WAN connections with the highest priority will be used.
To enable asymmetric connections, connection mapping to remote WANs, cut-off
latency, and packet loss suspension time, click the button.