Product Card
Table Of Contents
- 16 Port Forwarding
- 17 NAT Mappings
- 18 QoS
- 19 Firewall
- 20 Routing Protocols
- 21 Remote User Access
- 22 Miscellaneous Settings
- 23 AP
- 24 AP Controller Status
- 25 Toolbox
- 26 System Settings
- 27 Tools
- 28 Status
- 29 WAN Quality
- 30 Usage Reports
- Appendix A: Restoration of Factory Defaults
- Appendix B: Declaration
https://www.peplink.com
157
Copyright @ 2021 Pepwave
GPIO Menu
The Ignition Sensing options are available in Advanced > GPIO
The configurable option for Ignition Input is Delay; the time in seconds the router stays
powered on after the ignition is turned off.
Still under development:
O/P (connected to I/O pin on 4 pin connector) can be configured as a digital input, digital output
or analog input.
Digital Input - the connection supports input sensing; it reads the external input and determine
if the settings should be 'High' (on) or 'Low' (off).
Digital Output - when there is a healthy WAN connection, the output pin is marked as 'High' (on).
Otherwise, it will be marked as 'Low' (off).
Analog Input - to be confirmed. In most cases should read the external input and determine the
voltage level.
22.8 NTP Server
Pepwave routers can now serve as a local NTP server. Upon start up, it is now able to provide
connected devices with the accurate time, precise UTC from either an external NTP server or
via GPS and ensuring that connected devices always receive the correct time.
Compatible with: BR1 ENT, 700 HW3, HD2/4, Transit