User's Manual

https://www.peplink.com 29 Copyright @ 2019 Peplink
Connection Settings
WAN
Connection
Name
Indicate a name you wish to give this WAN connection
Enable
Click the checkbox to toggle the on and off state of this connection.
Routing Mode
This option allows you to select the routing method to be used in routing IP frames via the
WAN connection. The mode can be either NAT (Network Address Translation) or IP
Forwarding.
In the case if you need to choose IP Forwarding for your scenario. Click the button to
enable IP Forwarding.
Connection
Type
This option allows you to configure the WAN connection whether for normal daily usage or as
a backup connection only.
If Always-on is chosen, the WAN connection will be kept on continuously and is used for load
balancing.
If Backup Priority is chosen, the WAN connection will not be used unless none of the Always-
on connection(s) is available.
Standby State
This option allows you to choose whether to remain the connection connected or disconnect it
when this WAN connection is no longer in the highest priority and has entered the standby
state. When Remain connected is chosen, upon bringing up this WAN connection to active, it
will be immediately available for use. If this WAN connection is charged by connection time,
you may want to set this option to Disconnect so that connection will be made only when
needed.
Idle Disconnect
If checked, you can define the number of minutes of idle time has passed before a network