Users Manual

https://www.peplink.com 167 Copyright @ 2020 Peplink
area will be displayed beneath:
The allowed IP subnet addresses should be entered into this text area. Each IP
subnet must be in form of w.x.y.z/m, where w.x.y.z
is an IP address (e.g.,
192.168.0.0), and m is the subnet mask in CIDR format, which is between 0 and
32 inclusively (For example, 192.168.0.0/24).
To define multiple subnets, separate each IP subnet one in a line. For example:
192.168.0.0/24
10.8.0.0/16
Allowed WAN IP
Address(es)
This is to choose which WAN IP address(es) the web server should listen on.
11.1.2 Firmware
Upgrading firmware can be done in one of three ways.
Using the router’s interface to automatically check for an update, using the router’s interface to manually
upgrade the firmware, or using InControl2 to push an upgrade to a router.
The automatic upgrade can be done from System > Firmware.
If an update is found the buttons will change to allow you to Download and Update the firmware.
Click on the Download and Upgrade button. A prompt will be displayed advising to download the Current
Active Configuration. Please click on the underlined download text. After downloading the current config
click the Ok button to start the upgrade process.
The router will download and then apply the firmware. The time that this process takes will depend on your
internet connection’s speed.
The firmware will now be applied to the router*. The amount of time it takes for the firmware to upgrade will