User's Manual

https://www.peplink.com 33 Copyright @ 2020 Peplink
Optimal Network
Discovery
Cellular WAsN by default will only handover from 3G to LTE network when there is no active
data traffic, enable this option will make it run the handover procedures after fallback to 3G for
a defined effective period, even this may interrupt the connectivity for a short while.
Band Selection
When set to Auto,
band selection allows for automatically connecting to available, supported
bands (frequencies) .
When set to Manual, you can manually select the bands (frequencies) the SIM will connect to.
Data Roaming
This checkbox enables data roaming on this particular SIM card. When data roaming is enabled
this option allows you to select in which countries the SIM has a data connection. The option
is
configured by using MMC (country) codes.Please check your service
provider’s data roaming
policy before proceeding.
Authentication
Choose from PAP Only or CHAP Only to use those authentication methods exclusively. Select
Auto to automatically choose an authentication method.
Operator
Settings
This setting allows you to configure the APN settings of your connection. If Auto
is selected,
the mobile operator should be detected automatically. The connected device will be configured
and connection will be made automatically. If there is any difficul
ty in making connections, you
may select Custom to enter your carrier’s APN, Login, Password, and Dial Number
settings
manually. The correct values can be obtained from your carrier. The default and recommended
setting is Auto.
APN / Login /
Password /
SIM PIN
When Auto
is selected, the information in these fields will be filled automatically. Select
Custom
to customize these parameters. The parameter values are determined by and can be
obtained from the ISP.
Bandwidth
Allowance
Monitor
Check the box Enable to enable bandwidth usage monitoring on this WAN connection for each
billing cycle. When this option is not enabled, bandwidth usage of each month is still being
tracked but no action will be taken.
Action
If email notification
is enabled, you will be notified by email when usage hits 75% and 95% of
the monthly allowance. If Disconnect when usage hits 100% of monthly allowance
is
checked, this WAN connection will be disconnected automatically when the usage hit
s the
monthly allowance. It will not resume connection unless this option has been turned off or the
usage has been reset when a new billing cycle starts.
Start Day
This option allows you to define which day of the month each billing cycle begins.
Monthly
Allowance
This field is for defining the maximum bandwidth usage allowed for the WAN connection each
month.