Datasheet

Ultrasonic sensor UC2000-30GM70-IE2R2-V15
3
Release date: 2016-02-16 08:29 Date of issue: 2016-02-16 238386_eng.xml
Germany: [phone]Pepperl+Fuchs Group
Refer to “General Notes Relating to Pepperl+Fuchs Product Information”.
USA: [phone] Singapore: [phone]
www.pepperl-fuchs.com [e-mail] [e-mail]
[e-mail]
Description of Sensor Functions
Displays and Controls
The sensor has two potentiometers and two display LEDs.
The potentiometer function described illustrates the default function. The function of the potentiometer can be altered using the ULTRA-PROG-
IR software. As soon as a configuration has been changed, the potentiometer function selected using ULTRA-PROG-IR is activated.
Setting the Sensor Using the Potentiometers
The sensor is equipped with two potentiometers. These potentiometers are assigned to the switching output by default. The switching output
operates in window mode by default (2 switching points). Potentiometer 1 is used to set the near switching point of the switching window. Poten-
tiometer 2 is used to set the distant switching point of the switching window.
Note:
The function of the potentiometer can be altered using the ULTRA-PROG-IR software. As soon as a configuration has been changed, the poten-
tiometer function selected using ULTRA-PROG-IR is activated.
Parameterization via ULTRA-PROG-IR
In order to be able to set the sensor parameters and adjust the sensor to the respective application, the sensor is able to communicate with a PC
via the integrated infrared interface. The UC-18/30GM-IR interface cable is required to allow communication via this method. This cable is con-
nected to an unused USB port on the PC.
The ULTRA-PROG-IR parameterization software is also required for setting the sensor parameters. The ULTRA-PROG-IR software can be
downloaded for free from the www.pepperl-fuchs.com website. The software allows all open parameters to be set, including:
- All trip points and switching hystereses
- Output modes and behaviors
-Delay times
- Settings and setting ranges of the potentiometer
- Settings for teach-in and synchronization
- Definition of blind zones
- Sensor modes and measurement methods
- Filtering measurement values
The following service functions are also available:
- Observing and recording measurement values
- Diagnosing interference reflections
Teach-in
The sensor is equipped with a function input (XI). In order to teach in a limit value, this sensor must be parameterized as the Teach-in input using
the ULTRA-PROG-IR parameterization software. This parameterization software allows you to specify what limit value is taught in.
Accessories
BF 30
Mounting flange, 30 mm
BF 5-30
Universal mounting bracket for cylindrical sensors with a diameter of 5 ... 30 mm
V15-G-2M-PUR
Female cordset, M12, 5-pin, PUR cable
UC-18/30GM-IR
Interface cable
ULTRA-PROG-IR
Configuration software for ultrasonic sensors
LED 1 (yellow) On/off: Switching state of switching output
Flashing: Error when setting the switching
points (switching point 2 < switching point 1).
This state only occurs in window function ope-
rating mode (2 switching points).
LED 2 (yellow) On/off: Object between evaluation limit A1
and evaluation limit A2 in the analog evalua-
tion range.
LED 2 (green) approx. 500 ms on: Range limit taught in
Off: Normal mode
Potentiometer 1 Setting for switching point 1 of the switching
output.
Potentiometer 2 Setting for switching point 2 of the switching
output
LED 1
yellow
LED 2
yellow / green
potentiometer 2
potentiometer 1 temperature
sensor
connector
UC-18/30GM-IR
Sensor