Datasheet

Subject to reasonable modifications due to technical advances. Copyright Pepperl+Fuchs, Printed in Germany
Pepperl+Fuchs Group • Tel.: Germany [phone] • USA [phone] • Singapore [phone] • Internet http://www.pepperl-fuchs.com
Ultrasonic sensor UB1000-18GM75-E5-V15
4
Release date: 2011-08-12 13:07 Date of issue: 2011-08-12 204530_eng.xml
The ultrasonic sensor enables two different shapes of the sound cone, a wide angle sound cone and a small angle sound cone.
1. Small angle sound cone
• switch off the power supply
• connect the Teach-input wire to -U
B
• switch on the power supply
• the red LED flashes once with a pause before the next.
• yellow LED: permanently on: indicates the presence of an object or disturbing object within the sensing range
• disconnect the Teach-input wire from -U
B
and the changing is saved
2. Wide angle sound cone
- switch off the power supply
- connect the Teach-input wire with +U
B
- switch on the power supply
- the red LED double-flashes with a long pause before the next.
- yellow LED: permanently on: indicates an object or disturbing object within the sensing range
- disconnect the Teach-input wire from +U
B
and the changing is saved
Installation conditions
If the sensor is installed at places, where the environment temperature can fall below 0 °C, for the sensors fixation, one of the
mounting flanges BF18, BF18-F or BF 5-30 must be used.
In case of direct mounting of the sensor in a through hole using the steel nuts, it has to be fixed at the middle of the housing
thread. If a fixation at the front end of the threaded housing is required, plastic nuts with centering ring (accessories) must be
used.
pause
pause