Datasheet

1
Inductive sensor NBN4-F25-E8-V1
Release date: 2018-11-21 16:38 Date of issue: 2018-11-21 264860_eng.xml
Germany: [phone]Pepperl+Fuchs Group
Refer to “General Notes Relating to Pepperl+Fuchs Product Information”.
USA: [phone] Singapore: [phone]
www.pepperl-fuchs.com [e-mail] [e-mail]
[e-mail]
Model Number
NBN4-F25-E8-V1
Features
• Direct mounting on standard actuators
• Small construction with sturdy plastic
housing of protection class IP 67
•LED for power on
• M12 male connector
Accessories
BT32
Activator for F25 series
BT33
Activator for F25 series
BT34
Activator for F25 series
BT32XAS
Activator for F25 series
BT43-RG-01
Activator for F25 series including protective housing and
mounting plate
Technical Data
General specifications
Switching function 2 x normally open (NO)
Output type PNP
Rated operating distance s
n
4 mm
Installation flush mountable
Output polarity DC
Assured operating distance s
a
0 ... 3.24 mm
Actual operating distance s
r
3.6 ... 4.4 mm typ.
Reduction factor r
Al
0.5
Reduction factor r
Cu
0.4
Reduction factor r
304
1
Reduction factor r
St37
1.1
Output type 3-wire
Nominal ratings
Operating voltage U
B
10 ... 30 V DC
Switching frequency f 0 ... 1000 Hz
Hysteresis H typ. 5 %
Reverse polarity protection reverse polarity protected
Short-circuit protection pulsing
Voltage drop U
d
≤ 2.5 V
Design data
Operating current I
L
0 ... 200 mA
Off-state current I
r
0 ... 0.5 mA typ. 0.1 µA at 25 °C
No-load supply current I
0
≤ 22.5 mA
Time delay before availability t
v
≤ 100 ms
Operating voltage indicator LED, green
Switching state indicator LED, yellow
Functional safety related parameters
MTTF
d
860 a
Mission Time (T
M
) 20 a
Diagnostic Coverage (DC) 0 %
Ambient conditions
Ambient temperature -25 ... 70 °C (-13 ... 158 °F)
Storage temperature -40 ... 85 °C (-40 ... 185 °F)
Mechanical specifications
Connection type Connector plug M12 x 1 , 4-pin
Connector housing metal
Housing material PBT
Sensing face PC
Degree of protection IP67
Mass 48 g
Tightening torque, fastening screws M5 x 25 : 2.7 Nm
Note Mounted on mechanical drive
Compliance with standards and
directives
Standard conformity
Standards
EN 60947-5-2:2007
EN 60947-5-2/A1:2012
IEC 60947-5-2:2007
IEC 60947-5-2 AMD 1:2012
Approvals and certificates
UL approval cULus Listed
CCC approval CCC approval / marking not required for products rated ≤36 V
Dimensions
7
40
45°45°
30
R
20.8
ø 5.3
13
20
52
11
M12x1
52
LED
gn
LED
ye
LED
ye
LED
gn