Operation Manual

64
Basic Operations
3
1 Set the flash mode to C or D.
2 Press the shutter release button halfway.
The flash mode icon changes according to the mode that the camera
selects.
When E or F is selected, the built-in
flash pops up and begins charging. If the
camera determines that the flash is not
necessary, the flash mode icon will not be
shown.
3 Press the shutter release button fully.
The picture is taken.
4 Push down on the top of the flash in
the direction indicated in the
illustration to retract the built-in
flash.
Press the K/i button while the built-in flash is popped up to switch between
the auto flash and manual flash modes.
K-01_OPM_ENG.book Page 64 Wednesday, February 22, 2012 2:08 PM